Tredify

Materials

The right material depends on what the part has to do: carry a load, survive a hot car, stay outside, or show what a design looks like. These are the materials we work with. Not sure which one fits? Describe the part and we will advise.

At a glance

MaterialStrengthHeatOutdoor (UV)PriceBest for
Nylon PA123D printing, HP Multi Jet FusionhighhighmediummediumFunctional parts, clips, small series
PLA3D printing, FDMmediumlowlowlowPrototypes and models
PETG3D printing, FDMmediummediummediumlowEveryday functional parts
ABS3D printing, FDMmediumhighlowlowParts that get warm, car interiors
ASA3D printing, FDMmediumhighhighmediumOutdoor and exterior parts
AluminiumCNC machiningvery highvery highhighhighLoad-bearing, long-lasting parts

A general comparison between these materials; the shape and wall thickness of a part matter as much as the material.

Nylon PA123D printing, HP Multi Jet Fusion

A fine nylon powder fused layer by layer, without support structures. Parts are strong, slightly flexible and accurate, with a fine-grained grey surface, often dyed black. Most of our own 3Drive products are made this way.

Good for
Clips, holders, snap fits, moving parts, series of tens to hundreds
Not for
Glossy, decorative surfaces

PLA3D printing, FDM

The easiest plastic to print: rigid, accurate and inexpensive, in many colours. It softens at around 60 °C, so it does not belong in a car in summer.

Good for
First prototypes, fit tests, display models
Not for
Heat, outdoor use, parts under load for a long time

PETG3D printing, FDM

Tougher and less brittle than PLA, and more resistant to heat, moisture and many chemicals. A good default for practical parts around the house or workshop.

Good for
Brackets, covers, housings, parts that get wet
Not for
Dashboards and other places in full sun behind glass

ABS3D printing, FDM

A classic engineering plastic, also used for many original car parts. It handles higher temperatures than PLA and PETG and can be sanded and finished.

Good for
Interior car parts, enclosures, parts near heat
Not for
Long outdoor use: sunlight makes it yellow and brittle

ASA3D printing, FDM

Similar to ABS, but made to withstand sunlight and weather without fading or becoming brittle.

Good for
Exterior car parts, garden and outdoor fittings
Not for
Tight budgets where PETG would do

AluminiumCNC machining

Machined from a solid block. Stiffer, stronger and more heat-resistant than any plastic, and it can be anodised in colour.

Good for
Mounts, load-bearing parts, metal replacement parts
Not for
Complex organic shapes on a small budget

Not sure which one?

Tell us what the part is for, where it goes and how many you need. We recommend a material and a process.

Start a project